Keysight Technologies MSO-X 2002A - I;O Interface Settings

247
Keysight InfiniiVision 2000 X-Series Oscilloscopes
User's Guide
20 Utility Settings
I/O Interface Settings / 247
Setting up the Oscilloscope's LAN Connection / 248
File Explorer / 251
Setting Oscilloscope Preferences / 253
Setting the Oscilloscope's Clock / 256
Setting the Rear Panel TRIG OUT Source / 256
Performing Service Tasks / 257
Configuring the [Quick Action] Key / 262
Adding an Annotation / 263
This chapter explains oscilloscope utility functions.
I/O Interface Settings
The oscilloscope can be accessed and/or controlled remotely via these I/O
interfaces:
• USB device port on the rear panel (square shaped USB port).
• LAN interface when a LAN/VGA module is installed in the rear panel module
slot.
• GPIB interface when a GPIB module is installed in the rear panel module slot.
To configure the I/O interfaces:
1 On the oscilloscope's front panel, press [Utility].
2 In the Utility Menu, press I/O.
3 In the I/O Menu, press Configure.