Save/Recall (Setups, Screens, Data) 18
Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide 239
2 In the Save/Recall Menu, press Default/Erase.
3 In the Default Menu, press one of these softkeys:
• Default Setup— recalls the oscilloscope's default setup. This is the same as
pressing the front panel [Default Setup] key. See “Recall the Default
Oscilloscope Setup" on page 29.
Some user settings are not changed when recalling the default setup.
• Factory Default— recalls the oscilloscope's factory default settings.
You must confirm the recall because there are no user settings that are left
unchanged.
Performing a Secure Erase
1 Press the [Save/Recall] key.
2 In the Save/Recall Menu, press Default/Erase.
3 In the Default menu, press Secure Erase.
This performs a secure erase of all non-volatile memory in compliance with
National Industrial Security Program Operation Manual (NISPOM) Chapter 8
requirements.
You must confirm the secure erase, and the oscilloscope will reboot when
finished.
To Next Page
Loading...
