217
Keysight InfiniiVision 2000 X-Series Oscilloscopes
User's Guide
17 Waveform Generator
To select generated waveform types and settings / 217
To output the waveform generator sync pulse / 220
To specify the expected output load / 220
To use waveform generator logic presets / 221
To add noise to the waveform generator output / 222
To add modulation to the waveform generator output / 222
To restore waveform generator defaults / 227
A waveform generator is built into the oscilloscope. It is enabled by Option WGN
or the DSOX2WAVEGEN upgrade. The waveform generator gives you an easy way
to provide input signals when testing circuitry with the oscilloscope.
Waveform generator settings can be saved and recalled with oscilloscope setups.
See Chapter 18, “Save/Recall (Setups, Screens, Data),” starting on page 229.
To select generated waveform types and settings
1 To access the Waveform Generator Menu and enable or disable the waveform
generator output on the front panel Gen Out BNC, press the [Wave Gen] key.
When waveform generator output is enabled, the [Wave Gen] key is illuminated.
When waveform generator output is disabled, the [Wave Gen] key is off.
The waveform generator output is always disabled when the instrument is first
turned on.
The waveform generator output is automatically disabled if excessive voltage is
applied to the Gen Out BNC.
To Next Page
Loading...
Need help?
General
