Use Phillips head screwdriver to remove the screw
from the GPIB cover plate. Retain the screw for
use later in this procedure.
Then, remove the cover plate by sliding it to the
left.
Locate the connector, just inside the unit, to connect
the cable that is attached to the GPIB module.
Attach the cable to the connector located in the
previous step.
Put the module into the unit and slide the GPIB
board to the right so that it is flushed against the
instrument's sheet metal. Use the screw that was
removed earlier to secure the GPIB plate in place.
This concludes the GPIB installation procedure.
Keysight E36200 Series User's Guide 45
To Next Page
Loading...
Need help?
General
