DO NOT BLOCK VENTILATION HOLES
Do not block any of the ventilation holes of the device.
OBSERVE ALL DEVICE MARKINGS BEFORE CONNECTING TO DEVICE
Observe all markings on the device before connecting any wiring to the device.
TURN DEVICE OFF BEFORE CONNECTING TO OUTPUT TERMINALS
Turn off the device power before connecting to the output terminals.
ENSURE COVER IS SECURED IN PLACE
Do not operate the device with the cover removed or loosened.
TURN DEVICE OFF ANDREMOVEALL CONNECTIONS BEFORE INSTALLING THEGPIB INTERFACE
Turn off the power and remove all connections, including the power cord, from the instrument prior installation of the
GPIB interface.
ENSURE PROPER AWG CABLE IS USED
Use a cable with the correct voltage and AWG rating based on the intended setup when operating the E36200A Series
autoranging DC power supplies.
DO NOT TOUCH CABLES DURING OPERATION
Do not touch the cable while the instrument output is operational to prevent electric shock hazard and burn hazard.
CLEAN WITH SLIGHTLY DAMPENED CLOTH
Clean the outside of the instrument with a soft, lint-free, slightly dampened cloth. Do not use detergent, volatile
liquids, or chemical solvents.
CONNECT USB CABLE WITH FERRITE CORE
Connect a USB cable with a ferrite core to the rear panel USB port of the instrument for better performance.
Keysight E36200 Series User's Guide 9
To Next Page
Loading...
Need help?
General
