Measurement
109
This calibration procedure is applied when the following test fixtures are
connected to the 42942A's 7-mm port:
• 16092A Lead/Chip component test fixture
• 16192A Chip component test fixture
• 16454A Magnetic material test fixture
1. Make sure that the adapter selection is set to 7mm 42942A. Perform
Adapter Setup if it is not done yet.
2. When performing calibration for the 7-mm port of the E4990A with a
user-defined calibration kit, be sure to use the proper calibration kit.
Refer to User Calibration. User calibration is not required if you do
not use a user-defined calibration kit.
3. Connect a test fixture to the 7-mm port of the 42942A Terminal
Adapter. See the operation manual of each test fixture for the
appropriate connection setup.
To Next Page
Loading...
