Keysight E4990A - Outputting Data; Saving and Recalling Instrument State

Measurement
185
• When calling a limit table with zero segments
• When Clear Limit Table > OK is pressed in the Edit Limit Line menu
Outputting Data
Outputting Data
• Saving and Recalling Instrument State
• Saving/Recalling Instrument State for Each Channel into/from
Memory
• Saving Trace Data to a File
• Saving the Screen Image to a File
• Printing Displayed Screen
Saving and Recalling Instrument State
• Overview
• Saving Data
• Recalling Data
• Priority of Recalling Configuration File at Startup
Other topics about Data Output
Overview
You can save the instrument state of the E4990A into a file on mass
storage and then recall it later to reproduce that state. You can select the
stored data from the following four types.
Type Stored data and usage
State only
(State Only)
Saves the setting of the E4990A and reproduces the
state when it is saved by recalling it later into the
E4990A.
State and
calibration
data (State &
Cal)
Saves the setting of the E4990A and calibration data
(calibration coefficient array) to reproduce the state
when it was saved by recalling it later into the
E4990A. At this time, you can perform error
correction of measured values by using the recalled
calibration data.