Setting Control Functions
199
5. Change the setting of USB/GPIB interface.
Remote Control Using HTTP (Web Browser)
• Enabling Web Server
• Browser Web Control
Other topics about Setting Control Functions
You can access the web page installed in the E4990A by using the
hypertext transfer protocol (http) and the E4990A's IP address from the
external PC's web browser. This function is called web-enabled analyzer.
Through the built-in web page, you can control the E4990A remotely and
display the measurement screen on external PCs.
The following browsers are recommended:
• Internet Explorer 8.0 and later
Enabling Web Server
Network Configuration
To use web server, you have to configure the E4990A's network correctly.
For detailed information on configuration and notes, see
Configuring the
Network.
Enabling Web Server
Enable the web server for the E4990A so that it may allow access from an
external PC. Follow these steps:
1. Press System > Misc Setup > Network Setup.
2. Click Web Server to turn it ON.
Access from an external PC
1. Execute web browser on your PC.
2. Check IP address of the E4990A.
3. Enter IP address of the E4990A in the address bar and press Enter.
The following screen appears:
To Next Page
Loading...
