E4990A Help
174
^ Power
( Open parenthesis
) Close parenthesis
, Comma - separator for arguments
= Equal (optional)
E Exponent (as in 23.45E6)
Priority of operators is:
1. ^
2. *, /
3. +, -
Making Pass/Fail Evaluation (Limit Test)
• Overview
• Concept of Limit Test
• Displaying Judgment Result of Limit Test
• Defining Limit Line
• Changing the Limit Line Display Mode
• Using Relative Limit Line
• Adding Offset to Limit Line
• Initializing the Limit Table
Other topics about Analysis and Processing of Result
Overview
The limit test feature allows you to set the limit line for each trace and
then perform the pass/fail judgment for the measurement result.
Concept of Limit Test
The limit test is a function to perform pass/fail judgment based on the limit
line you set with the limit table.
In the limit test, if the upper limit or lower limit indicated by the limit line
is not exceeded, the judgment result is pass; if it is exceeds, the judgment
To Next Page
Loading...
