Keysight E4990A - Setting Control Functions; Setting the GPIB

197
Setting Control Functions
Setting Control Functions
Remote Control

Setting the GPIB
 Remote Control Using HTTP (Web Browser)
Display

Turning off the Date/Time Display
 Turning off the LCD Screen Backlight
 Calibration of the Touch Screen
Others

Exit/Restart E4990A Measurement Application
 Checking the Product Information
 Backing Up License Key File
 Locking the Front Keys, Keyboard, and/or Mouse (Touch Screen)
 Setting the Beeper (Built-in Speaker)
 Setting the preset function
Setting the GPIB
• Setting talker/listener GPIB address of E4990A
• Setting system controller (USB/GPIB interface)
Other topics about Setting Control Functions
This section describes how to set the interface necessary to use the GPIB
(General Purpose Interface Bus) of the E4990A.
Setting talker/listener GPIB address of E4990A
When controlling the E4990A using GPIB commands from the external
controller connected to the GPIB connector, you need to set the
talker/listener GPIB address of the E4990A.
Follow these steps to make this setting:
1. Press System > Misc Setup > GPIB Setup> Talker/Listener Address.
2. Enter the address using the ENTRY block keys on the front panel.
Setting system controller (USB/GPIB interface)