Keysight E4990A - Calibration; Selecting Appropriate Calibration Method

To Next Page

To Previous Page

Measurement

this is ON

Selecting the Segment Sweep as the Sweep Type

To execute a segment sweep by using the segment table you have

created, you must specify the sweep type for that sweep operation by

following the steps below.

1. Press Sweep Setup display the sweep setup menu.

2. Press Sweep Type > Segment.

Setting the Horizontal Axis of the Graph (Frequency/Order Base Display)

Define the method of displaying traces when the segment sweep is

executed by following the steps described below.

1. Press Sweep Setup display the sweep setup menu.

2. Press Segment Display > Freq Base|Order Base.

Calibration

This chapter describes calibration methods for the E4990A Impedance

Analyzer.

• Selecting Appropriate Calibration Method

• A. Direct Connection Type Test Fixture

• B. Calibration for Four-Terminal Pair, 1-m Extension

• C. Calibration for Four-Terminal Pair, 2-m Extension

• D. Exclusive Fixture

• E. 42942A, 7-mm Port Extension

• F. 42941A, Probe Adapter

• G. 42941A, 3.5-mm Port Extension

• User Calibration

• Port Extension Compensation

• Fixture Compensation

• Selecting Calibration/Compensation Data Points

Selecting Appropriate Calibration Method

Other manuals for Keysight E4990A