Keysight E4990A - Setting Channels and Traces

E4990A Help
72
or
Execute the :SYST:PRES command.
*RST state Execute the *RST command.
Factory
default
setting
E4990A factory (default) settings.
The user can set items to be preset freely. For more information, see
Setting the user preset function.
Other topics about Setting Measurement Conditions
Setting Channels and Traces
• Overview of Channel and Trace
• Setting Channel Display (Layout of Channels)
• Changing Active Channel
• Setting Trace Display
• Changing Active Trace
Other topics about Setting Measurement Conditions
Overview of Channel and Trace
The E4990A allows you to setup multiple channels to perform
measurement under different stimulus conditions.
As multiple traces (measurement parameters) can be displayed for each
channel, no feature is provided to link the stimulus conditions between
channels, and each channel is always independent of the others. In other
words, you need to set the measurement conditions and execute
calibration for each channel you use for measurement.
When you set items whose setting target is channels/traces (refer to
Parameter setting for each setup item), the target is the selected (active)
channel/trace. You can specify only the displayed channels/traces as active
channels/traces. Therefore, set the display of channels/traces before
setting the measurement conditions.
Setting Parameter for each Setup Item (Analyzer, Channel, Trace)
The following table lists the setting parameters and indicates the setup
item (analyzer, channel, or trace) that each parameter controls along with
the applicable setup key(s).