E4990A Help
218
You can enable/disable the network connection function of the E4990A.
To enable/disable the network connection function
1. Use the LAN cable to connect the E4990A to the LAN.
2. Press System > Misc Setup > Network Setup > Network Configuration
to open Network Connections window.
3. Perform either of the following:
• When switching from disable to enable:
Double-click the Local Area Connection icon in the Network Connections
window to enable the network connection function.
• When switching from enable to disable:
Double-click the Local Area Connection icon in the Network Connections
window. The Local Area Connection Status screen appears. Click the
Disable button to disable the network connection function.
4. Close Network Connections window.
Check/Reset IP Address
The IP address of the E4990A can be checked/reset by System > Misc
Setup > Network Setup > LAN Dialog.
Setting IP address
Follow these steps to set the IP address:
1. Press System > Misc Setup > Network Setup > Network Configuration.
2. Double-click the Local Area Connection icon in the Network
Connections window. The Local Area Connection Status screen
appears.
3. Click Properties. The Local Area Connection Properties screen appears.
4. Select (highlight) Internet Protocol (TCP/IP), and then click Properties.
5. The Internet Protocol (TCP/IP) Properties appears. Click (select) Use the
following IP address and then enter the IP address, subnet mask and
gateway address.
6. If the IP address can be obtained automatically (if the DHCP server
can be used), click (select) Obtain an IP address automatically.
7. In Internet Protocol (TCP/IP) Properties, click OK.
8. In Local Area Connection Properties, click OK.
9. In Local Area Connection Status, click Close.
10. Close Network Connections window.
To Next Page
Loading...
