E4990A Help
208
• When calibration data measurements are
done
• When data storage has completed
Warning beeper
Emits a beep tone to prompt the user to use
caution.
• When an instrument error occurs (An error
message appears at the same time.)
• When a limit test fails
The operations complete beeper emits slightly longer than the warning
beeper.
Setting the Operation Complete Beeper
1. Press System > Misc Setup > Beeper > Beep Complete to switch the
operation complete beeper ON/OFF.
2. Clicking Test Beep Complete allows you to hear and check the beep
tone of the operation complete beeper.
Setting the Warning Beeper
1. Press System > Misc Setup > Beeper > Beep Warning to switch the
warning beeper ON/OFF.
2. Clicking Test Beep Warning allows you to hear and check the beep
tone of the warning beeper.
Setting the Preset Function
• Showing/hiding the confirmation buttons when presetting
• Setting the user preset function
• Saving a user-preset instrument state
Other topics about Setting Control Functions
Showing/hiding the confirmation buttons when presetting
The preset function can be executed without displaying the OK and Cancel
softkey buttons when pressing the preset button of the E4990A.
1. Press System > Misc Setup > Preset Setup.
2. Confirm to toggle ON (show)/OFF (hide) the confirmation buttons.
Setting the user preset function
To Next Page
Loading...
