Keysight E4990A - Setting up the Display of Measurement Results; Selecting the Measurement Parameters

Measurement
123
20, 50, 100, 200, 500, 1000, 1200, 1500, 1900, 2300, 2800, 3500,
4300, 5300, 6600, 8100
10k, 11k, 11.4k, 11.400001k, 12,1k, 13.3k, 14.7k, 16.2k, 17.8k, 19.6k,
21.5k, 22.9k, 22.900001k, 23.7k, 26.1k, 28.7k, 31,6k, 34.8k, 38.3k,
42.2k, 46.4k, 51.1k, 56.2k, 61.9k, 68.1k, 75k, 82.5k, 90.9k, 91.6k,
91.600001k
100k, 110k, 121k, 133k, 147k, 162k, 178k, 196k, 215k, 237k, 261k,
287k, 316k, 348k, 383k, 422k, 464k, 511k, 562k, 619k, 681k, 750k,
825k, 909k
1M, 1.1M, 1.2M, 1.3M, 1.4M, 1.4648M, 1.464800001M, 1.5M, 1.7M, 2M,
2.5M, 3M, 3.5M, 4M, 4.5M, 5M, 5.2083M, 5.208300001M, 6M, 7M, 8M,
9M
10M, 11M, 12M, 13M, 14M, 15M, 15.000000001M, 16M to 120M (1M
step, 105pts)
Other topics about Calibration
Setting Up the Display of Measurement Results
Setting Up the Display of Measurement Results
This chapter describes how to configure the E4990A Impedance Analyzer
to display the measurement results in the way that best suits your needs.
• Selecting the Measurement Parameters
• Selecting the Graph Axis Format
• Scaling Trace
• Trace-based Comparison and Calculation
• Monitoring Source Signal Level
• Setting for Phase
• Setting Windows Display
Selecting the Measurement Parameters
• Selecting Parameters for both traces 1 and 2
• Selecting Parameter Independently