Keysight E4990A - Page 108

E4990A Help
98
1. Press Sweep Setup display the sweep setup menu.
2. Press Edit Segment Table. The segment table appears in the lower
section of the screen.
3. Select the softkey below to change the frequency range setting mode
for each segment.
Softkey
Label
Function
Freq Mode
Switches the frequency range setting mode
(Start/Stop or Center/Span)
List OSC
Level
Toggles ON/OFF the OSC level setting for each
segment; the column for OSC Mode and OSC Level
only appears in the segment table when this is
turned ON
List Bias
Toggles ON/OFF the bias setting for each segment;
the column for Bias Mode and Bias Level only
appears in the segment table when this is turned
ON
List Meas
Time
Toggles ON/OFF the measurement time setting for
each segment; the column for Meas Time only
appears in the segment table when this is turned
ON
List
Average
Toggles ON/OFF the averaging value setting for
each segment; the column for Point Avg only
appears in the segment table when this is turned
ON
List
Segment
Time
Toggles ON/OFF the segment sweep time setting
for each segment; the column for Segment Time
setting only appears in the segment table when
this is ON
List
Segment
Delay
Toggles ON/OFF the sweep delay time setting for
each segment; the column for Segment Delay
setting only appears in the segment table when