Measurement
183
Adding Offset to Limit Line
By adding a certain offset to the limit value, you can adjust the limit line so
that it conforms to the device output.
1. Press Channel Next (or Channel Prev) and Trace Next (or Trace Prev) to
select the channel/trace on which the limit test function is used.
2. Press Analysis > Limit Test to display the softkeys for the limit test.
3. Click Limit Line Offsets to display the limit line offset function menu
as below.
Softkey Function
Stimulus
Offset
Adds a certain offset to the stimulus value of the
entire segment in the limit table. (Stimulus offset)
Amplitude
Offset
Adds a certain offset to the response value of the
entire segment in the limit table. (Amplitude
offset)
Marker ->
Amplitude
Offset
Adds the amplitude offset by the same amount as
the retrieved value of the active marker. You can
confirm the current value set for the amplitude
offset by pressing Amplitude Offset. (Marker
amplitude offset)
Stimulus offset
To Next Page
Loading...
