E4990A Help
252
Type A: USB host port
Type B: USB (USBTMC) interface port
Preparing E4990A
You do not have to configure any softkey or command of the E4990A in
order to control the E4990A from an external controller. Simply connect a
USB cable to the USB interface port.
Driver Installation
1. You must install the Agilent I/O Libraries on your PC in advance.
2. Connect the E4990A with your PC via USB cable. The driver is
installed automatically at the first time connection. It takes a few
minutes.
Getting VISA/SICL address
1. From your PC's Start menu, click Program > Agilent I/O Libraries Suite
> Agilent Connection Expert to open the Agilent Connection Expert
setting screen.
2. Click Refresh All.
3. The E4990A appears under USB0.
4. Click it, then address information is displayed.
To Next Page
Loading...
