Programming
255
Grammar of Messages
This section describes the grammar to send program messages via GPIB.
Program messages are messages that the user sends to the instrument
from the external controller to control the instrument. A program message
consists of 1 or more commands and their necessary parameters.
Upper/lower case sensitivity
Upper/lower case insensitive.
Program message terminator
A program message must be terminated with one of the 3 program
message terminators: <new line>, <^END>, or <new line><^END>.
<^END> indicates that EOI on the GPIB interface becomes active at the
instant when the immediately previous data byte is sent. For example, the
OUTPUT command of HTBasic automatically sends the message terminator
after the last data byte.
Parameters
To Next Page
Loading...
