Keysight E4990A - Navigating E4990 A Help; Conventions used in E4990 A Help

Table of Contents
v
Adapter Selection .......................................................................... 63
Adapter Setup .............................................................................. 63
Setting Measurement Conditions ........................................................ 71
Setting Measurement Conditions ..................................................... 71
Initializing Parameters ................................................................... 71
Setting Channels and Traces .......................................................... 72
Selecting Sweep Parameter ............................................................ 79
Setting Source .............................................................................. 89
Setting Trigger ............................................................................. 92
Calibration ...................................................................................... 99
Calibration ................................................................................... 99
Selecting Appropriate Calibration Method ......................................... 99
A. Direct Connection Type Test Fixture .......................................... 103
B. Calibration for Four-Terminal Pair, 1-m Extension ....................... 104
C. Calibration for Four-Terminal Pair, 2-m Extension ....................... 106
D. Exclusive Fixture ..................................................................... 108
E. 42942A, 7-mm Port Extension .................................................. 110
F. 42941A, Probe Adapter ............................................................ 112
G. 42941A 3.5mm Port Extension ................................................. 114
User Calibration .......................................................................... 116
Port Extension Compensation ....................................................... 118
Fixture Compensation .................................................................. 119
Selecting Calibration/Compensation Frequency Points ...................... 121
Setting Up the Display of Measurement Results ................................. 123
Setting Up the Display of Measurement Results .............................. 123
Selecting the Measurement Parameters ......................................... 123
Selecting the Graph Axis Format ................................................... 126
Scaling Trace .............................................................................. 127
Trace-based Comparison and Calculation ....................................... 129
Monitoring Source Signal Level ..................................................... 132
Setting for Phase ........................................................................ 133
Setting Windows Display .............................................................. 134
Analysis and Processing of Result..................................................... 141