Measurement
77
You specify the trace display by setting the number of traces (upper limit
of displayed trace numbers). For example, if you set the number of traces
to 3, traces 1 through 3 are displayed.
The procedure for setting the number of traces is as follows:
1. Press Channel Next (or Channel Prev) to select the channel for which
you want to set the number of traces.
2. Press Display > Number of Traces.
3. Press the desired softkey to set the number of traces.
Setting trace layout (graph layout)
Traces are laid out and displayed in the order of the trace number from
graph 1 according to the graph layout in the channel window.
You can select the graph layout from the windows layout.
If the number of traces is less than the number of graphs, nothing is
displayed in the remaining area. If the number of traces you set exceeds
the number of graphs, excess traces are superimposed from the first
graph. For example, if you select as the graph layout and
set the number of traces to 4, graph 1 (Gr1 in Graph layout) display traces
1 and 2, respectively, by superimposing, and graph 2 (Gr2 in Graph
layout) and graph 3 (Gr3 in Graph layout) displays trace 2 and trace 4 as
shown in the figure below.
To Next Page
Loading...
