Safety features of your vehicle
163
Seat belts
twisted. &ach belt assembly must
only be used by one occupant; it is
dangerous to put a belt around a
child being carried on the occupant's
lap.
Australian design rules
䳜 No modifications or additions
should be made by the user which
will either prevent the seat belt
adjusting devices from operating
to remove slack, or prevent the
seat belt assembly from being
adjusted to remove slack.
䳜 When you fasten the seat belt, be
careful not to latch the seat belt
in buckles of other seat. It's very
dangerous and you may not be
protected by the seat belt prop
-
erly.
䳜%o not unfasten the seat belt and
do not fasten and unfasten the
seat belt repeatedly whilst driv
-
ing.This could result in loss of
control, and an accident causing
death, serious injury, or property
damage.
䳜 When fastening the seat belt,
make sure that the seat belt does
not pass over objects that are
hard or can break easily.
䳜 Make sure there is nothing in the
buckle. The seat belt may not be
fastened securely.
Seat belt warning
Driver䳓s seat belt warning
As a reminder to the driver, the
driver䳓s seat belt warning lights will
illuminate for approximately 6 sec
-
onds each time you turn the ignition
switch or &NGIN& STA3T/ST0P but
-
ton 0N regardless of belt fastening.
If the seatbelt is not fastened, the
warning chime will sound for about
6 seconds.If you start to drive with
-
out the seat belt fastened or you
unfasten the seat belt when you
drive under 20 km/h or stop, the
corresponding warning light will illu
-
minate.
If you start to drive without the
seat belt fastened or you unfasten
the seat belt when you drive 20 km/
h and faster, the warning light will
blink and warning chime will sound
for approximately 100 seconds.
When the seat belt is unfastened
during driving, the warning light will
illuminate when the speed is under
20 km/h.
When the speed is 20 km/h and
faster, the warning light will blink
and warning chime will sound for
approximately 100 seconds.
To Next Page
Loading...
