105
7
7
Maintenance -ight bulbs
Daytime running lamp/Position
lamp (-ED Type) replacement
(Headlamp Type C)
If the daytime running lamp/posi
-
tion lamp (LED) (1) does not oper
-
ate, have your vehicle checked by a
professional workshop.
Kia recommends to visit an autho
-
rised Kia dealer/service partner.
The LED lamps cannot be replaced
as a single unit because it is an inte
-
grated unit. The LED lamps has to
be replaced with the unit.
A skilled technician should check or
repair the daytime running lamp/
position lamp (LED), for it may dam
-
age related parts of the vehicle.
Front fog lamp (bulb type) bulb
replacement (Fog lamp type A)
1. Disconnect the negative (-) bat
-
tery terminal.
2. Disconnect the side after loosen
-
ing the front bumper sides screws
and clips.
3. Disconnect the front fog lamp
connector.
4. 3emove the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.
. 3emove the bulb from the socket
by pressing it in and rotating it
counter-clockwise until the tabs
on the bulb align with the slots in
the socket. Pull the bulb out of
the socket.
6. Insert a new bulb by inserting it
into the socket and rotating it
until it locks into place.
7. Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assembly.
To Next Page
Loading...
