Maintenance
107
-ight bulbs
Push the socket into the assem
-
bly and turn the socket clockwise.
8. Connect the front fog lamp con
-
nector.
. Install the front bumper side
assembly to the body of the vehi
-
cle.
Front fog lamp (-ED type) bulb
replacement (Fog lamp type B)
If the front fog lamp (LED) (1), does
not operate, have your vehicle
checked by a professional workshop.
Kia recommends to visit an autho
-
rised Kia dealer/service partner.The
LED lamps cannot be replaced as a
single unit because it is an inte
-
grated unit. The LED lamps has to
be replaced with the unit.A skilled
technician should check or repair the
front fog lamp (LED), for it may
damage related parts of the vehicle.
Rear turn signal lamp bulb replace
-
ment
1. Open the tail gate.
2. Loosen the light assembly retain
-
ing screws with a cross-tip
screwdriver.
3. 3emove the rear combination
lamp assembly from the body of
the vehicle.
4. Disconnect the rear combination
lamp connector.
. 3emove the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.
6. 3emove the bulb from the socket
by pressing it in and rotating it
counterclockwise until the tabs on
To Next Page
Loading...
