Kone NanoSpace - After the Rescue

KONE NanoSpace™
Owner’s Manual
152 (196) OM-01.03.086
(B) 2016-01-11
© 2014 KONE Corporation
All rights reserved.
11.8 After the rescue
This section describes how to store the rescue clamp if it has been used, reset the pit safety
device and shaft access monitor (SAM), and how to reset the alarm on LCERAL board.
WARNING! Use protective cut-resistant safety gloves.
Check that the safety device has triggered.
Install the ladder.
1088359.wmf
1089562.wmf
SGI
1
08380
2.wmf
1083838.wmf