KONE NanoSpace™
Owner’s Manual
77 (196) OM-01.03.086
(B) 2016-01-11
© 2014 KONE Corporation
All rights reserved.
10.2 Safety measures
WARNING! Failing to complete the safety measures can cause death or serious injury.
You must plan all work carefully in order to avoid any safety hazards or damage to the
product. Perform the following actions:
– Check that there is no one inside the car or in the elevator shaft during the safety
inspection.
– Disconnect the landing calls using the user interface during
the safety inspection,
so that the inspection is not interrupted and passengers are not trapped in the
elevator.
– Before going to the elevator car roof, push the car roof stop button down and turn
the inspe
c
tion drive unit to inspection drive before releasing the stop button.
Safety tests are to be carried out by authorized persons only.
WARNING! Prior to carrying out any of the tasks described below ensure the following:
– There are visual "Under maintenance" signs on all the landings.
– Safety fences are used to prevent any unauthorized access to the working area.
Step Action Illustration/Note
1 Travel in the elevator car to the
topmost floor.
Put “Under maintenance” signs to all
landings.
2 Prevent unauthorized access to the
working area.
Use safety fences.
To Next Page
Loading...