Kone NanoSpace - Page 39

KONE NanoSpace™
Owner’s Manual
38 (196) OM-01.03.086
(B) 2016-01-11
© 2014 KONE Corporation
All rights reserved.
Table 9: Elevator safety precautions
Safety precautions Note
Develop and follow procedures that
have assimilated
the requirements of
national elevator codes and other
safety related regulations.
In case of conflict between the code and
these instructions, carry out a full risk
assessment and define an appropriate
course of action with the local regulator and
company management.
Local safety codes and rules must be
followed if the
y exceed KONE
standards. Otherwise use the safe
working methods defined herein.
Refer to your local procedures to take the
elevator out of use.
Follow the safe working methods
defined
herein. If you are uncertain of
the method's safety, seek expert
advice.
Follow this instruction. Do not skip any
steps with
in the sub-procedures.
Skipping steps creates potentially
dangerous situations which you have
not considered.
Warning signs highlight possible hazards.
Be sure that you only use maintenance
instructions that apply to
your elevator
configuration. If you are unsure, contact
KONE.
ENSURE THAT ELECTRICAL
EQUI
PMENT AND CONDUCTORS
ARE SAFELY DE-ENERGISED
BEFORE WORKING ON THEM.
A locking off system for the main
electric supply isolator or,
for example,
fuse removal or locking and tagging
system when applicable, must be
agreed with the person responsible for
the building’s electrics.
Do not connect or disconnect any
connectors whe
n the power is on.
Personal safety equipment must be
available and u
sed as required.
If there is a risk of injury from a fall,
adequate
fall prevention system must
be in place.
Handle and dispose of waste materials
in accordan
ce with company
procedures that have assimilated the
local regulations.