KONE NanoSpace™
Owner’s Manual
60 (196) OM-01.03.086
(B) 2016-01-11
© 2014 KONE Corporation
All rights reserved.
8.4.2 Inspection of the safety gear and wedges
1. Clean the wedges if dusty and oily. Clean away iron scrap if it exists.
2. Check for cracks. The surface of the wedges mu
st not have cracks.
3. Check the overall wear of the wedge. Replace both safety gears as a pair after 12
trippings, 100
% load at full speed.
4. Check the governor rope fixing and the screw joint between the rope fixing and the lever.
Check that the fixing screws a
re not loose and that the lever is not bent or broken.
8.4.3 Inspection of the safety gear sideward movement
1. Check that the safety gear can move sideways.
2. Ensure that the counter wedge can contact the guide rail when
the safety gear engages.
Steps
1 – 3
1077699.wmf
To Next Page
Loading...