Detail
For details on the AppleTalk settings of this machine, refer to "Network settings" on page 3-3.
Specifying the AppleTalk settings for the computer
Specify the AppleTalk settings for the Macintosh computer connected to this machine.
1 On the "Apple" menu, select "System Preferences".
2 Click the "Network" icon.
3 From "Show", select "Built-in Ethernet".
4 Click the AppleTalk tab, and then select the "Make AppleTalk Active" check box.
5 Click the close button at the top left of the dialog box.
– When the "Apply configuration changes?" message appears, click the [Apply] button.
Adding a printer (AppleTalk settings)
1 Select "HDD" - "Applications" - "Utility" where the driver was installed, and then double-click "Printer
Setup Utility" or "Print Center" to open it.
2 When the Add Printer dialog box appears, click the [Add] button. When the printer list appears, click
the [Add] button.
– If available printers have already been set up, the Add Printer dialog box does not appear.
3 Select "AppleTalk" for the connection method, and then select the zone to which this machine is
connected.
– If the printer is not detected, turn off this machine, then on again.
– When turning off the power, then on again, wait at least 10 seconds before turning it on again.
Otherwise, this machine may not function properly.
The connected printers are detected.
4 From the "Name" list, select the desired model name.
5 Select "KONICA MINOLTA" in "Printer Model", select the desired model from the list of model names,
and then click the [Add] button.
If the selected printer is registered in the printer list, the setting procedure is completed.
Specifying the TCP/IP setting for this machine (LPR settings)
Specify the IP address of this machine.
To Next Page
Loading...
