Konica Minolta magicolor 8650 - Automatically Conserving Energy (Low Power Mode); Automatically Conserving Energy (Sleep Mode); Manually Switching to Power Save Mode; Power Supply

magicolor 8650 2-19
Before using the machine
2
2.2.4 Automatically conserving energy (Low Power mode)
If no operation is performed for a specified length of time the machine automatically enters a mode where it
conserves energy.
This is the Low Power mode.
The machine can receive jobs even while it is in Low Power mode.
As the factory default, the machine enters Low Power mode after 15 minutes.
2
Note
When a print job is received, the machine recovers from Low Power mode and begins printing after it
has finished warming up.
The Low Power mode can also be canceled by pressing any key in the control panel.
!
Detail
The length of time until the machine enters Low Power mode can be changed. For details, refer to
"System Settings" on page 9-18.
2.2.5 Automatically conserving energy (Sleep mode)
If no operation is performed for a specified length of time, the machine automatically enters a mode where it
conserves energy.
This is the Sleep mode.
Although the machine conserves more energy in Sleep mode than in Low Power mode, the machine must
warm up when Sleep mode is canceled to begin printing again, therefore taking more preparation time than
Low Power mode.
As the factory default, the machine enters Sleep mode after 20 minutes.
2
Note
When a print job is received, the machine recovers from Sleep mode and begins printing after it has
finished warming up.
The Sleep mode can also be canceled by pressing any key in the control panel.
!
Detail
The length of time until the machine enters Sleep mode can be changed. For details, refer to "System
Settings" on page 9-18.
2.2.6 Manually switching to Power Save mode
Power Save mode can be manually specified from the control panel.
If "Immediately" is specified for "Entering Power Save" on the control panel, this machine stops all the
functions. However, the machine automatically returns from the Power Save mode when the control panel is
operated or data is being sent.
2.2.7 Power supply
Be sure to turn off the machine if it is not to be used for a long period of time, for example, overnight.
In order to ensure that no energy is being consumed, unplug the machine.
EDNord - Istedgade 37A - 900 Aalborg - telefon 9633 3500