kruss K11 MK3 - Page 5

Contents page 3
7.3 Measuring surface tension by the plate method...............................................................43
7.4 Measuring interfacial tension by the plate method ...........................................................44
8 Ring method measurements........................................................................ 47
8.1 Measuring parameters in the main menu of the ring method...........................................47
8.1.1 Measuring mode ........................................................................................................47
8.1.2 Correction...................................................................................................................48
8.1.3 Reading limit .............................................................................................................. 50
8.1.4 Heavy density.............................................................................................................50
8.1.5 Light density...............................................................................................................50
8.1.6 Relaxation / switching to the ring tear-off mode ......................................................... 50
8.1.7 Ring type....................................................................................................................51
8.2 Parameters for the ring method in Setup ......................................................................... 52
8.2.1 Measuring speed........................................................................................................52
8.2.2 Detection speed .........................................................................................................52
8.2.3 Immersion depth ........................................................................................................ 53
8.2.4 Immersion speed (mm/min)........................................................................................ 53
8.3 Measuring surface tension by the ring method ................................................................54
8.4 Measuring interfacial tension by the ring method............................................................. 56
8.4.1 Interfacial tension pull................................................................................................. 56
8.4.2 Interfacial tension push ..............................................................................................59
9 Density measurement.................................................................................. 62
9.1 Parameters for the density measurement in Setup ..........................................................62
9.1.1 Detection speed (mm/min) .........................................................................................62
9.1.2 Immersion speed (mm/min)........................................................................................ 63
9.2 Measuring the density...................................................................................................... 63
9.3 Entering the density of a different probe .......................................................................... 66
10 Basic settings (setup menu and special functions) .................................... 67
10.1 First page of the setup menu ........................................................................................... 68
10.1.1 measuring speed........................................................................................................68
10.1.2 Immersion speed........................................................................................................68
10.1.3 Detection speed .........................................................................................................69
10.1.4 Acceleration due to gravity......................................................................................... 69
10.2 Second page of the setup menu ...................................................................................... 70
10.2.1 Immersion depth ........................................................................................................ 70