16 ENGINE 143
300121-10
– Take the clutch out of the vise and lay it on a clean workbench with the outer
clutch hub
facing down.
–
Take the inner clutch hub
and release springs
out of the outer clutch
hub
.
300122-10
–
Take off the clutch facing discs
from the inner clutch hub.
–
Remove pretension ring
and support ring
.
– Clean all parts well.
– Check the clutch. ( p. 143)
16.4.30 Checking the clutch
Preparatory work
– Disassemble the antihopping clutch. ( p. 142)
305657-10
Main work
–
Check pressure piece
for damage and wear.
» If there is damage or wear:
– Change the pressure piece.
–
Check axial bearing
for damage and wear.
» If there is damage or wear:
– Change the axial bearing.
To Next Page
Loading...
