11 Oscilloscope (continued)
67 of 86
BetrHbKRC2FL--USA--Fehler 11.04.00 en
11.1.15 Switching c urves on and off
It can sometimes be necessary to completely remove individual curves from the display. To
do so, open the information window by pressing the softkey “Info”.
Select the curve that you would like to remove from the display. The curve that is currently
selected is highlighted by a color background. Now press the Enter key.
Now close the information window again.
As you can see, your action has been registered. The deactivated curve is now no longer
displayed.
To Next Page
Loading...
