User Manual
60 of 86
BetrHbKRC2FL--USA--Fehler 11.04.00 en
11.1.10 Print
If you would like to print out the contents of the screen, please press the softkey “Print”.
The screen is printed on the current default printer of the operating system; the printer
should be set to “Landscape”.
11.1.11 The cursor functions
Press the softkey “===>” repeatedly until the cursor functions appear in the softkey bar.
Using these functions, you can place two vertical and two horizontal lines (cursors) inside
the window. This enables you to determine the value that a curve represented at a certain
time quite easily.
The color of the active curve is permanently displayed at the bottom left of the window. To
change it, press the softkey “===>” repeatedly until the following functions appear in the
softkey bar.
Press the softkey “Channel” until the color of the desired curve is active.
Active color: Blue
Change the softkey bar again and then press the softkey “VCursor1”. A vertical white line
is displayed in the window.
Active color: Magenta
To Next Page
Loading...
