EasyManua.ls Logo

Kurzweil K2000 - GUIDE SUPPLEMENT - VERSION 3

Kurzweil K2000 - GUIDE SUPPLEMENT - VERSION 3
234 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-52
Song Mode and Sequencing
The Song Editor (EditSong Pages)
A negative ramp is the opposite; the new values are applied immediately at the bar and beat
defined by the From parameter, then the events gradually go back toward their original values
as the song progresses toward the bar and beat defined by the To parameter.
Figure 3-1 shows how the setting for Mode affects the result of a change. In each case, attack
velocities are scaled down to 25% over the two-bar segment from 2:1 to 4:1
Figure 3-1 Effect of Mode on Change function
Track Functions: Thin
Use the Thin function to reduce the number of events recorded for any Controller type within
the selected segment. This is useful because sometimes you can get the same effect from a
Controller even if you remove some of the events. This is an easy way to save memory, and
possibly avoid some of those annoying delays that occur when there’s too much MIDI
information getting sent.
EditSong:TRACK|||||||||||||||<>Track:1||
Function:Thin||||d|From||:||1:1|To:||2:1
Percent|:50%|||||d||||||||||||||||||||||
|||||||||||||||||d|Ctl|||:MPress||||||||
|||||||||||||||||d|LoVal|:0|||||Hi:127||
|||||||||||||||||d||||||||||||||||||||||
Locate||:||1:1|||'%%^^^^^^^^%%%%%%^%%%%%
FromTo||Play|||Stop||||||||||Go||||Done|
Percent
The value of the Percent parameter determines how much thinning occurs. A value of 0% means
no thinning. The default value of 50% removes half the events of the currently selected
Controller type (as specified by the Ctl parameter). A value of 100% removes most events of the
selected type—but not all. Some events are never removed, including all Pitch Bend messages
with a value of 0, and initial settings for many Controllers, such as volume and pan.
Track Functions: Remap
Use the Remap function to convert events from one Controller type to events of another
controller type. Both types of events must occur within the selected segment.
New values
2:1 4:1
Location
127
1
Velocity
Original values
New values
2:1 4:1
Location
127
1
Velocity
Original values
2:1 4:1
Location
127
1
Velocity
Original values
New values
31
51
109
32
Constant PosRamp NegRamp

Table of Contents

Related product manuals