3-20
Song Mode and Sequencing
Song Mode: The MAIN Page
Programs selected in Program Mode or from a Quick Access bank will be selected as the
program on the current RecTrk when you return to Song mode.
SongMode:MAIN||Events:186K|||STOPPED||||
CurSong:1|NewSong||||||||||||Tempo:120||
RecTrk|:Mult|Vol:127|Pan:64||Mode|:Merge
Chan:4||2|Stereo|Grand|||||||Locat:||1:1
||||||||||||||||||||||||||||||||||||||||
Track||:R|R|R|R|R|R|R|R|R|R|R|R|R|R|R|R|
Channel:1|2|3|4|5|6|7|8|9|10111213141516
Record||Play|||Stop||Erase||MISC||MIXER|
Chan (Channel)
This parameter determines the control channel and is only available when the RecTrk is set to
None or Mult. The Program parameter value remains on the display and can be edited, even
though the parameter's name, "Program,” no longer appears.
Setup
Displays the ID and name of the setup to be recorded. This parameter is available by setting
RecTrk to Mult, then entering Setup mode momentarily by pressing the Setup button followed
by the Song button to return to Song mode. The screen below shows an example of the Song
mode page with the Setup parameter displayed.
SongMode:MAIN||Events:186K|||STOPPED||||
CurSong:1|NewSong||||||||||||Tempo:120||
RecTrk|:Mult|Vol:127|Pan:64||Mode|:Merge
Setup||:4|Total|Orchestra|||Locat:||1:1|
||||||||||||||||||||||||||||||||||||||||
Track||:R|R|R|R|R|R|R|R|R|R|R|R|R|R|R|R|
Channel:1|2|3|4|5|6|7|8|9|10111213141516
Record||Play|||Stop||Erase||MISC||MIXER|
In this case, the Chan parameter will be replaced with Setup. It is important to know how many
channels, and consequently how many tracks, are needed for recording a particular setup. Each
setup can have up to three zones that can respond to your playing differently, depending on
what range of the keyboard is being played, or if certain velocity and/or controller values
determines when a particular zone will respond. Be aware of the behavior of each setup you
intend to record so that you can allocate the proper tracks and channels needed in your song.
Volume (Vol)
You can set an initial volume level for the playback and recording of each track as a value
between 0 and 127. If the channel of the RecTrk (or the control channel, if RecTrk is set to Multi
or None) contains any recorded volume change (controller code 7), the change will be reflected
as the Vol parameter’s value in real time.
To Next Page
Loading...
Need help?
General
