Song Mode and Sequencing
The Song Editor (EditSong Pages)
3-53
Use the Old and New parameters to remap Controller types. For example, the following
diagram indicates that all MWheel messages (the old type) in the segment from 1:1 to 2:1 will
become Volume messages (the new type) when the Go button is pressed. The actual values of
the MWheel messages won’t change, just the Controller type.
EditSong:TRACK|||||||||||||||<>Track:1||
Function:Remap|||d|From||:||1:1|To:||2:1
Old|||||:MWheel||d||||||||||||||||||||||
New|||||:Volume||d||||||||||||||||||||||
|||||||||||||||||d||||||||||||||||||||||
|||||||||||||||||d||||||||||||||||||||||
Locate||:||1:1|||'%%^^^^^^^^%%%%%%^%%%%%
FromTo||Play|||Stop||||||||||Go||||Done|
The available values for Old and New are 0–120. Values appear as numerals, except for named
Controllers (like MWheel and Breath).
Track Functions: Grab
Grab is a little like Copy, in that it involves selecting song data and placing it into another track.
The similarity ends there, however. When you copy song data, you copy from the current track,
then choose another track in the same song and place the copied data there. When you grab data,
first you copy the data from a selected segment in any track of any song (these are called the
source track and the source song). Then you choose a destination track in the current song and
place the copied data there.
You can grab all events, or just certain types of events. Use the parameters in the
Region/Criteria window to specify which events to grab. In the following diagram, for example,
we’re going to grab all MWheel events in the first bar of the source track.
EditSong:TRACK|||||||||||||||<>Track:1||
Function:Grab||||d|From||:||1:1|To:||2:1
SrcSong|:1|NewSond|Events:Controllers|||
DstTrack:1|||||||d|Ctl|||:MWheel||||||||
Location:||1:1|||d|LoVal|:0|||||Hi:127||
Times|||:1|||||||d||||||||||||||||||||||
Locate||:||1:1|||'%%^^^^^^^^%%%%%%^%%%%%
FromTo||Play|||Stop||||||||||Go||||Done|
SrcSong (Source Song)
The value of SrcSong defines the source song—the song from which you’re going to grab events.
It can be any existing song—including the current song Once you’ve chosen a source song, use
the CHAN/BANK buttons to select a source track. The source track appears at the top right of
the display. It can be any single track from 1–16, or it can be all tracks. In the preceding diagram,
the source song is 1 NewSong, and the source track is Track 1.
DstTrack (Destination Track)
This parameter selects the destination track (in the current song) for the grabbed events. All
selected events from the source track(s) get placed at a specified location in the destination
track(s). If the source track is All, then the destination track automatically becomes All, and each
source track maps to its corresponding destination track (1 to 1, 2 to 2, and so on). Empty tracks
don’t get grabbed.
To Next Page
Loading...
Need help?
General
