4-14
Disk Mode Enhancements in Version 3
Disk Mode Functions
selected object is done by pressing Select again. The asterisk will disappear. The easiest way to
choose objects for loading is by scrolling the list and individually pressing Select on each object
that you want to load.
If you only want to select one object for loading, you need not select it with the Select button.
Instead, pressing OK will implicitly select the highlighted object if there are no other objects
selected.
This screen shows three samples selected for loading:
Func:LOAD|||||Sel:3/20||||||Index:|||||4
Sample||201*Machine|Snare||||C|4S|||100K
Sample||203*Big|Bass|Loop||||C|4S|||218K
Sample||304*Distorted|Riff|||C|4S|||401K
Sample||305|EPiano1||||||||||D|2|||||24K
Sample||306|EPiano2||||||||||D|3|||||25K
Sample||313|EPiano3||||||||||D|4|||||15K
Select||Next|||Type||Multi||||OK||Cancel
The Next button will cause the index into the list to jump to the next selected object, forward in
the list. When the end of the list is reached, the search will wrap around from the beginning. If
you have more than one object selected, then if you repeatedly press Next you can easily cycle
through all selected items. If there are no items selected, then this button doesn't do anything.
The Type button jumps to the next object of a different type from the one that is currently
highlighted. This is a convenient way to find a particular type of object in the list. If you want to
skip over the samples and the keymaps in an object list and jump right to the programs, press
Type about two or three times, stopping when you notice that a program is highlighted.
Press the Multi button to enter the Multiple Object Selector (described on page 4-30.) This
powerful utility can be used to control the selection or deselection of many objects, cross-
referenced by object types and ranges of ID numbers.
When you are all done selecting objects to load, press OK. As stated above, if only one object is
to be loaded, it is implicitly selected if it is the currently highlighted object and there are no other
selected objects in the list.
Cancel returns to the file list dialog, highlighting the file you just opened. You can load the
entire file after pressing Cancel by pressing OK when you return to the file list.
Shortcuts when Loading Objects
Select All/Deselect All
Selecting or deselecting all of the objects at once can be done with the same double presses as
described for the file list dialog, namely:
• Left/Right cursor double-press: Select all objects
• Up/Down cursor double-press: Clear all selections
If you want to load most but not all of the items from a file (for instance, if there happens to be a
Master Table in the file that you don't want to load), it may be fastest to first select all objects
using the Left/Right double press, and then manually deselect any unwanted items.
To Next Page
Loading...
Need help?
General
