Sampling with the K2000
Editing Samples
2-21
7 Invert
Use this function to invert the waveform of the selected sample range. The results will vary
depending on the type of sample. For an interesting phase effect, make a copy of a sample, then
invert the copy, then assign it to the keymap of a second layer in a program that uses the original
sample in the keymap of the first layer (or set them as the Left and Right samples in a stereo
keymap). Add a delay to one of the layers or keymaps to create the phase effect.
8 Insert Zero
This function inserts a period of silence of any length into the selected sample range—
equivalent to splicing a section of blank tape into an existing segment of recorded tape. It’s
useful for creating a delay on the start of a sample, or creating a silent spot in the middle or at
the end of the sample. Adjust the Start parameter to determine the point at which the period of
silence will begin. Adjust the Length parameter to specify how long the silence will be. The End
parameter has no effect for this function.
9 Mix
F:Invert|||||Start:0.000||||End:6.000|||
||||||||||||||||||||||||||||||||||||||||
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
-6dB>|||||||||||||||||||||||||||||||||||
****************************************
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
F:InsertZero|Start:0.000||||End:6.000|||
Length:0.000||||||||||||||||||||||||||||
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
-6dB>|||||||||||||||||||||||||||||||||||
****************************************
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
F:Mix||||||||Start:0.000||||End:6.000|||
FadeIn:0.000||||Out:0.000||||VolAdj:0dB|
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVCurve:LIN|
-6dB>|||||||||||||||||||||||||||||||||||
****************************************
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
To Next Page
Loading...
Need help?
General
