4-12
Disk Mode Enhancements in Version 3
Disk Mode Functions
The Load Object feature is accessible from within the Load File dialog. To activate it, scroll the
file list until you have highlighted the file that you wish to load objects from:
Dir:\||||||||||||Sel:0/6|||||Index:|||3|
|||||||||||||||||BASSDRMS|.KRZ||||426K||
|||||||||||||||||HIHATS|||.KRZ||||788K||
||||File|to|load:SAXES||||.KRZ|||2510K||
|||||||||||||||||TOMS|||||.KRZ||||301K||
|||||||||||||||||TOMS1||||.KRZ|||1400K||
|Total:|5037K||||XCYMB||||.KRZ|||1012K||
Select||Root||Parent||Open|||OK|||Cancel
Press Open to begin the Load Object dialog. (Note: The file must have a .KRZ extension in
order to load individual objects from it.) The K2000 then scans the file contents in order to
present a list of all of the objects in the file. Sometimes this procedure can take a few moments,
depending on how many objects are in the file. During this time, you will see the following
display:
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Reading|file|SAXES.KRZ||[...]|||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Select||Next|||Type||Multi||||OK||Cancel
The soft buttons in the above display do not become active until the process of scanning is
finished. When this happens, the K2000 will display a list of the file's objects, in the exact order
that they are stored in the file:
Func:LOAD|||||Sel:0/5|||||||||||Index:|1
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Sample||200|Tenor|Sax1|||||||G|2S|||250K
Sample||201|Tenor|Sax2|||||||C|3S|||179K
Sample||203|Tenor|Sax3|||||||F#3S|||198K
Keymap||200|Tenor|Sax|||||||||||||||176|
Select||Next|||Type||Multi||||OK||Cancel
The objects in the list are usually grouped by type (sample, program, keymap, etc.) The list can
be scrolled using the Alpha Wheel or the Up/Down cursors. The CHAN/BANK buttons on the
front panel can be used for fast scrolling.
Note: When scrolling through large numbers of objects (more than 100), the K2000 may
sometimes pause for a few seconds if it needs to get more information from the disk file. When
this happens, some gyrating dots will briefly appear in place of the Index value on the top line of
the screen.
To Next Page
Loading...
Need help?
General
