Default Setting (System Menu)
8-114
4 Press the OK key. The Service Setting menu
appears.
5 Press the U or V key to select [Drum Refresh].
6 Press the OK key. A confirmation screen appears.
7 Press [Yes] (the Left Select key). Completed. is
displayed and the screen returns to the Adjust/
Maint. menu.
Altitude Adj. (Altitude adjustment setting)
This sets the altitude adjustment mode. If you are using the machine at an altitude of 1500 m or higher and print
quality has deteriorated, the Altitude Adjustment mode setting can be used to restore print quality.
Use the procedure below to set the altitude adjustment setting.
1 In the Sys. Menu/Count. menu, press the U or V
key to select [Adjust/Maint.].
2 Press the OK key. The Adjust/Maint. menu
appears.
3 Press the U or V key to select [Service Setting].
Service Setting:
a
b
*********************
2
Network Status
3
Test Page
[ Exit ]
1
Service Status
Start the drum
refresh.
Are you sure?
[ Yes ] [ No ]
Sys. Menu/Count.:
a
b
;
Document Box
<
Edit Destination
*********************
[ Exit ]
=
Adjust/Maint.
Adjust/Maint.:
a
b
*********************
2
Send/Box Density
3
AutoColorCorrect
[ Exit ]
1
Copy Denst. Adj.
To Next Page
Loading...
Need help?
General
