Appendix-20
The label surface must be covered completely with the
top sheet. Gaps between labels may cause peeling of
labels, resulting in a serious failure.
Some label paper has large margins on the top sheet. When using such paper, do not peel these margins from
the carrier sheet before completing output.
Use label paper that conforms to the following specifications.
Colored Paper
Colored paper must conform to the specifications listed on the page 14
of the Appendix. In addition, the
pigments in the paper must be able to withstand the heat of printing (up to 200°C or 392°F).
NOTE: If you use colored paper quite often, we recommend to use paper feeder (multi purpose).
Preprinted Paper
Preprinted paper must conform to the specifications listed on the page 12
of the Appendix. The colored ink must
be able to withstand the heat of printing. It must be resistant to silicone oil as well. Do not use paper with a
treated surface such as glossy paper used for calendars.
Recycled Paper
Recycled paper must conform to the specifications listed on the page 14
of the Appendix; however, its
whiteness may be considered separately.
NOTE: Before purchasing recycled paper in volume, try testing a sample to ensure that the print quality.
Item Specifications
Top sheet weight 44 to 74 g/m²
Basis weight
(overall paper weight)
104 to 151 g/m²
Top sheet thickness 0.086 to 0.107 mm
Overall paper thickness 0.115 to 0.145 mm
Moisture content 4 to 6 % (composite)
Top sheet
Not allowedAllowed
Carrier sheet
To Next Page
Loading...
Need help?
General
