Installing and Setting up the Machine > Command Center RX
119
Changing Device Information
1
Display the screen.
1 Launch your Web browser.
2 In the address or location bar, enter the machine's IP address or the host name.
Click in the following order to check the machine's IP address and the host name.
[DeviceInformation] in the home screen > [Identification/Wired Network]
3 Log in with administrator privileges.
4 Click [System] from the [Device Settings] menu.
2
Specify the host name.
Enter the device information, and then click [Submit].
IMPORTANT
After changing the setting, restart the network or turn the machine OFF and then ON. To restart the network
interface card, click [Reset] in the [Management Settings] menu, and then click [Restart Network] in
"Restart".
To Next Page
Loading...
