Installing and Setting up the Machine > Default Settings of the Machine
85
Energy Saver function
If a certain period of time elapses after the machine is last used, the machine automatically enters Sleep to
minimize power consumption.
Sleep
To enter Sleep, select the [Energy Saver] key, touch panel and all indicators on the operation panel will go out to
save a maximum amount of power except the Energy Saver indicator. This status is referred to as Sleep.
If print data is received during Sleep, the machine automatically wakes up and starts printing.
For fax-compatible models, when fax data arrives while the machine is in Sleep, the machine automatically wakes
up and starts printing.
In addition, the machine wakes up when the following operations are performed:
• Select any key on the operation panel.
• Touch the touch panel.
• Place originals in the document processor.
• Open the document processor.
Recovery time from Sleep Mode is as follows.
6.0 seconds or less
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
Auto Sleep
Auto Sleep automatically switches the machine into Sleep if left idle for a preset time.
The amount of time before entering Sleep is as follows.
• 1 minutes (default setting)
To change the preset sleep time, refer to the following:
➡ Configuring Settings Quick Setup Wizard (page 89)
To Next Page
Loading...
