Operation on the Machine > Using a Fax Server to Send (Fax Server Send)
261
Using a Fax Server to Send (Fax Server Send)
You can send a scanned document via a fax server.
NOTE
• A fax server is required to use this function. For information about the fax server, contact the applicable
administrator.
• FAX server settings must be configured to send a FAX. For details, refer to the following:
➡ Command Center RX User Guide
➡ Fax Server (page 494)
1
[Home] key > [Send]
2
Place the original.
➡ Loading Originals (page 220)
3
Display the screen.
In the destination screen for sending, select [+] > [Fax Server].
4
Enter the recipient information.
1 Select [Fax No. Entry].
2 Enter the fax number > [OK]
NOTE
• Use the numeric keys to enter a number.
• When selecting On for "Entry Check for New Dest.", the re-entering screen for the destination
information appears.
➡ Re-entering the New Destination (page 269)
Destinations can be changed later.
➡ Checking and Editing Destinations (page 267)
To Next Page
Loading...
