System Menu > SecuritySettings
500
[Software Verification] Verify the software in the machine.
Select [Start] to run the verification.
If you experience any abnormalities in software verification, contact your
service representative.
[Administrator Authentication on
Firmware Update]
Request administrator to approve when updating firmware.
Value: [Off], [On]
[Allowlisting] In case if the unauthorized program or the program that has tampered
are installed, the stored data or the contents of the communication in
this program might be stolen. Once this function is activated, execution
of the unauthorized software or the tampering of the software can be
prevented, and possible to maintain the reliability of the system.
Value: [Off], [On]
NOTE
• After setting it to [On], you need to shutdown and restart the machine.
• Enabling this feature slows the machine start-up.
• If malware is detected, an event report can be used as a way to
understand its content. The Event reports can be enable by the
Command Center RX > "Management Settings: Notification/Report" >
[Recipient 1 E-mail Address] to [Recipient 3 E-mail Address] and [Notify
when Malicious Program is Detected] is set to [On].
[Administrator Authentication on
Data Import/Export]
Request approval from the administrator when importing/exporting
data.
Value: [Off], [On]
Item Description
To Next Page
Loading...
