Kyocera FS FS-1920 - Print Density

Configuration
1-95
Print Density
The print density can be adjusted in five steps: from 01 (light) to 05 (dark).
The factory setting is 03.
1
Press the MENU key.
2
Press the or key repeatedly until Print Quality > appears.
3
Press the > key.
4
Press the or key repeatedly until >Print Density appears.
5
Press the ENTER key. A blinking question mark (?) appears.
6
Select the print density from five steps from 01 (light) to 05 (dark)
using the or key.
7
Press the ENTER key.
8
Press the MENU key. The message display returns to Ready.
Print Quality >
>Print Density
03
>Print Density
? 03