Configuration
1-100
Sleep Timer Setting
The printer has a sleep timer to conserve power when the printer is not
printing, processing, or receiving data. You can adjust the timer value, the
length of time the printer waits before entering sleeping mode in the
absence of data.
1
Press the MENU key.
2
Press the or key repeatedly until Others > appears.
3
Press the > key.
4
Press the or key repeatedly until >Sleep Timer > appears.
The default setting is 015 min.
5
Press the ENTER key. A blinking cursor ( _ ) appears.
6
Press the or key to increase or decrease the value of the figure
where the cursor is blinking and set the desired time. The timer can
be set between 5 and 240 min, in 5-minute increments. You can use
the > and < keys to move the cursor right and left.
7
Press the ENTER key.
8
Press the MENU key. The message display returns to Ready.
Others >
>Sleep Timer >
015 min.
>Sleep Timer
015 min.
To Next Page
Loading...
Need help?
General
