Lanmage 6600C - UC Arm Rotation; Detector Rotation; One-Key Operation

6600 Product manual
Operator Manual
34
The movement range of UC arm up/down movement is 45cm ~ 165cm; in case of
reaching the limit position, the UC arm assembly can lock automatically; within the limit,
release the button, the UC arm assembly will automatically lock in the current position, and
the corresponding window of touch screen will show the current UC arm height.
5.4.3 UC Arm Rotation
: Press this button and hold, UC arm will make counterclockwise rotation
around the axis.
: Press this button and hold, UC arm will make clockwise rotation around the
axis.
The angle range of UC arm rotation is 0°
～
105°; if the UC arm height is too low, to
prevent the detector from hitting the ground, the function of UC arm counterclockwise
rotation will be automatically locked, then you can press the UC arm UP button, to lift the
UC arm above the rotation limit, and then perform the counterclockwise rotation (when the
UC arm height is too low, the clockwise rotation will not be affected.) Within the permissible
limit, release the button, and the UC arm assembly will automatically lock in the current
angle, then the corresponding window of touch screen displays the current UC arm angle.
5.4.4 Detector Rotation
In this configuration, the rotation motion of the detector can be manually controlled to
achieve photography angles of -5°, 0° and 30°.
5.4.5 One-key Operation
To facilitate the operation of medical staff, this frame increases the function of one-key
operation of under-table position and chest-film 1.8m position.
Automatic button of under-table position:
Press this button, the equipment
will move to 1.0m chest position automatically.
Automatic button of Chest-film 1.8m Position:
Press this button, if the UC
arm assembly is within the limits of the movement, the equipment will move to under-table
position automatically.
Emergency Stop switch: in case of an emergency, you can press the red 3mergency
stop switch to cut off the host power supply. Red emergency stop switch is located on the
top of the control panel assembly and column electric cabinet. In case of Reset, slightly