6600 Product manual
Operator Manual
82
9.2 Replace instructions
1. Cut off the power supply;
2. Dismantle the shell of machine frame and disconnect wires of replacement part;
3. Take out the part needs to be replaced and reinstall a new one carefully.
NOTE: For operation safety, only original parts shall be allowed to use during
replacement.
4. Wiring the part and give power to test the function of equipment.
9.3 Replace the collimator lamp
1) The specifications of the indicator light need to be the same as the original one;
2) Disconnect the power supply;
3) Remove the rear baffle;
4) Remove the indicator cover;
5) Remove the damaged indicator light;
6) Install with the indicator light of the same specification to ensure that the pins of
the indicator light are fully inserted into the lamp holder;
7) Check if the indicator area and the X-ray area correspond;
8) If you need to remove the indicator light, rotate 180° around the axis and reinsert it.
To Next Page